麻花豆星空天美糖心mv-星麻花传媒mv-星空天美梦幻mv免费-天美麻花星空果冻mv-62星空天美梦幻糖心mv-天美电影免费在线观看1. Before starting work, introduce a small amount of grease from the air inlet nozzle to ensure the working characteristics and service life of the riveter.

2. Maintain the required inlet operating pressure. If the working pressure of air inlet is too small, the output power of riveting hammer will be reduced. All iron core pulling rivets not only have low riveting efficiency, but also are likely to crack due to excessive hammering frequency.

3. Press the button lightly after the punch has tightened the bolt. If not, part of the piston rod will be damaged.

4. Safety protection bullet yellow is used to connect the punching needle and the gun body firmly to prevent the punching needle from flying out and damaging people or goods.

5. Hold the handle with your left hand and press the button with your ring finger to start the riveter. You can use the key to adjust the air compression size to ensure the stable operation of the riveter. At the beginning of riveting, because the bolt rod is long, the gap between the bolt rod and the riveting hole is very large, so the bolt rod is very easy to bend when hammered. Therefore, the button should be pushed to reduce the output power of the riveting gun. When the bolt rod is covered with the riveting hole, the output power of the bolt can be increased to quickly produce the pier head. When the head is close to the end, the pressure button is slowly released. The stainless steel hippocampus core pulling rivet can avoid the pier head from being too low.

麻花豆星空天美糖心mv-星麻花传媒mv-星空天美梦幻mv免费-天美麻花星空果冻mv-62星空天美梦幻糖心mv-天美电影免费在线观看6. The tail end of the punch pin is configured according to different types and specifications of the riveting gun. It can not be used in series to prevent damage to parts and reduce high efficiency. 7. It is not allowed to empty the gun in application to prevent damage to parts.